Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Women of SWPA Series: Effective Methods To Eliminate Clogging of Solids-Handling Pumps

Empowering Women in Industry

Women of SWPA Series: Effective Methods To Eliminate Clogging of Solids-Handling Pumps

In this webinar series, we’re partnering with the Women of SWPA to talk about the wastewater industry, today’s challenges and opportunities within the industry, and what the future holds for it. Charli sits down with Rana Elbittibssi to chat about “Flushable” wipes and eliminating clogging caused by these wipes.

As Infrastructure ages and loads increase on our wastewater treatment systems, operators are demanding equipment that delivers more efficiency, greater reliability, and lower life cycle cost. Leading manufacturers are finding ways to deliver these contradictory goals by integrating intelligent controls and sensors into state-of-the-art hardware which can act autonomously to deal with problems and optimize performance without operator intervention.

Rana Elbittibssi, is a professional engineer, with bachelor’s and master’s degrees in mechanical engineering from Concordia University in Montreal Quebec.

Rana’s role at Xylem is Regional Products Manager Americas, has been with Xylem for over 18 years, and has more than 25 years of experience in pumps, mixers, and rotating equipment that function within water, wastewater treatment, transport, solid management, industrial and water infrastructure markets.

Watch more of the Women of SWPA educational series.

Related Articles

Related Whitepapers

How to Read a Pump Curve (and Why you Want to)

If you have ever worked with pumps before, be it in an installation, maintenance, or engineering capacity, chances are high you have seen a pump…

Design Optimization of Jet Fuel Pump for Aviation

Jet fuel pumps play a critical role in the safe and efficient operation of commercial aviation. The performance and reliability of these pumps directly impact…

The Cost Of Downtime In Manufacturing [Infographic]

Downtime can be the most expensive element of any manufacturing operation. Here are some important facts and tips you should know to cut down on…

AFT Fathom used to Model Central Heating Cycle of a State-of-the-art Combined Heat and Power Plant

Kerem Algüzey, design engineer at ENKA Insaat ve Sanayi A.S., used AFT Fathom to simulate the central heating cycle to inform the design of the…

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *