Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Hydra-Cell® System Meets Pressure and Footprint Requirements

Pumps & Operations

Hydra-Cell® System Meets Pressure and Footprint Requirements

A manufacturer of high-technology membranes for Reverse Osmosis (RO) and other filtration applications in water and wastewater treatment needed to source a continuous-duty pump to recover solvents from a solution.

Wanner Hydra-Cell® System Meets Pressure and Footprint Requirements (1)

The company selected the Hydra-Cell D03/G03 model pump because of its capability to meet the flow and high-pressure requirements while taking up a minimal amount of space on its skid.

Wanner Hydra-Cell® System Meets Pressure and Footprint Requirements

Pump Model: D03EKSGHFEHA
Flow: up to 1.8 gpm (6.8 l/min)
Discharge Pressure: up to 870 psi (60 bar)
Application: Solution containing solvents Acetone,
Ethanol & Acetonitrile

The Hydra-Cell D03/G03 operates on a continuous-duty cycle at up to 870 psi (60 bar). The solvents in question may vary from 5-10% concentration in the initial feed and include Acetone, Ethanol and Acetonitrile. A final concentration in excess of 40% can be achieved by subjecting the membranes to more than 798 psi (55 bar) pressure.

The minimal maintenance seal-less design and low energy consumption of Hydra-Cell were also considered to be of great benefit. After more than one year of operation, no pump failures have been reported.

Related Articles

A World Without Pumps Medicine

A World Without Pumps: Medicine

Delivering Wellness Without Pumps: One Drop at a Time In a world without pumps, wellness comes slowly. It drips, slower than…

Related Whitepapers

How to Read a Pump Curve (and Why you Want to)

If you have ever worked with pumps before, be it in an installation, maintenance, or engineering capacity, chances are high you have seen a pump…

Design Optimization of Jet Fuel Pump for Aviation

Jet fuel pumps play a critical role in the safe and efficient operation of commercial aviation. The performance and reliability of these pumps directly impact…

The Cost Of Downtime In Manufacturing [Infographic]

Downtime can be the most expensive element of any manufacturing operation. Here are some important facts and tips you should know to cut down on…

AFT Fathom used to Model Central Heating Cycle of a State-of-the-art Combined Heat and Power Plant

Kerem Algüzey, design engineer at ENKA Insaat ve Sanayi A.S., used AFT Fathom to simulate the central heating cycle to inform the design of the…

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *