Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors

Control Freak™ Ensures Accuracy for Batch Processing of Plastics

Pumps & Operations
Wanner Control FreakTM Ensures Accuracy for Batch Processing of Plastics

Control Freak™ Ensures Accuracy for Batch Processing of Plastics

A plastics processor adds mineral oil to color concentrates to use as a plasticizer in the batch processing of plastics. Since the amount of mineral oil used will vary depending upon the formulation of a particular plastic product, accurate metering is paramount.

The processor selected a Hydra-Cell D10/G10 equipped with a Control Freak touch-screen metering controller to ensure accuracy. Control Freak features built-in programming so the user can enter the desired flow rate or volume and system pressure. It automatically runs the pump manually at the desired flow rate or volume/total time, or in pre-set batches.

Wanner Control FreakTM Ensures Accuracy for Batch Processing of Plastics

Pump Model: D10XKCTSFECA with Control Freak controller
Flow Rate: 150 to 300 gph (568 to 1136 l/min)
Pressure: 60 psi (4.1 bar)
Application: Metering mineral oil for batch processing of plastics

The D10/G10 is gravity-fed from a drum that is continuously fed from overhead totes. The Control Freak™ not only controls the operation of the D10/G10, it provides a flexible, economical way to manage dispense rates and volumes for accurate batches.

Related Articles

A World Without Pumps Medicine

A World Without Pumps: Medicine

Delivering Wellness Without Pumps: One Drop at a Time In a world without pumps, wellness comes slowly. It drips, slower than…

Related Whitepapers

How to Read a Pump Curve (and Why you Want to)

If you have ever worked with pumps before, be it in an installation, maintenance, or engineering capacity, chances are high you have seen a pump…

Design Optimization of Jet Fuel Pump for Aviation

Jet fuel pumps play a critical role in the safe and efficient operation of commercial aviation. The performance and reliability of these pumps directly impact…

The Cost Of Downtime In Manufacturing [Infographic]

Downtime can be the most expensive element of any manufacturing operation. Here are some important facts and tips you should know to cut down on…

AFT Fathom used to Model Central Heating Cycle of a State-of-the-art Combined Heat and Power Plant

Kerem Algüzey, design engineer at ENKA Insaat ve Sanayi A.S., used AFT Fathom to simulate the central heating cycle to inform the design of the…

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *